Revel C32 - Manual (Page 11)

11
ON TOP OF MONITOR
Set the Placement Compensation switch to
On Top of Monitor if the C32 loudspeaker
is placed on top of a video monitor as
shown in Figure 6 in the previous column
(middle) or a shelf.
If desired, spike footing can be added to
the bottom of the cabinet to create the
proper tilt angle. Refer to the Adjustable
Spike Footing section that begins on the
next page for additional information.
STAND MOUNTED
Set the Placement Compensation switch to
Stand Mounted if the C32 loudspeaker is
placed on a stand as shown in Figure 7 in
the previous column (bottom). An optional
pedestal stand is available at authorized
Revel dealers.
CAUTION
Loudspeakers placed on stands or on
top of video monitors may fall if tipped
or improperly positioned.To avoid this,
anchor the loudspeaker and stand using
the same procedures and hardware used
to anchor bookcases, wall units, and
other furniture. Harman Specialty
Group assumes no responsibility for
proper selection and installation of
hardware or for any personal injuries or
product damages resulting from improper
installation or a fallen loudspeaker.
Front or Large Rear
Projection Screen
Front
Left
Front
Right C32
(Center)
Optional
Pedestal Stand
Figure 7: Stand Mounted
Left Right
Rear Projection Screen
or
Large Direct-View Monitor
C32
(Center)
Figure 5: Flush Mounted
Rear Projection Screen
or
Large Direct-View Monitor
Front
Left
Front
Right
C32
(Center)
Figure 6: On Top of Monitor