Revel Salon 2 - Manual (Page 18)

Ultima Salon2/Studio2
Owner’s Manual
16
BI-WIRED CONNECTIONS
Bi-wired connections are made between both pairs of the Salon2/
Studio2 input terminals and one power amplifier output channel
as shown in Figure 9.
To make bi-wired connections:
1. Remove the jumper straps identified in Figure 4, page 9.
2. Connect one pair of loudspeaker wires to the high-frequency
of Salon2/Studio2 input terminals. Then connect the same
pair of loudspeaker wires to the desired power amplifier
output channel.
3. Connect another pair of loudspeaker wires to the low-
frequency pair of Salon2/Studio2 input terminals. Then
connect the loudspeakers to the same power amplifier output
channel that was selected in Step 2.
4. Make sure that all terminals are firmly hand-tightened.
Figure 9: Bi-Wired Connections
OUTPUT
POWER
AMPLIFIER
STUDIO2
Normal
Contour
Boundary