Revel Salon 2 - Manual (Page 16)

Ultima Salon2/Studio2
Owner’s Manual
14
Minimum Wire Gauge • Vertical bi-amplified connections must be made with
identical power amplifiers. Horizontal bi-amplified
connections can be made with identical or non-identical
power amplifiers with identical gain factors.
• When making bi-amplified connections, both power
amplifiers must receive identical input signals from the
associated preamplifier. A “Y” adaptor is required if the
associated preamplifier does not offer two connectors per
output channel. Otherwise, each power amplifier can be
connected to a separate connector for the same output
channel of the preamplifier.
• If desired, contact an authorized Revel dealer for information
about the suitability of power amplifier components before
connecting the Salon2/Studio2 to the associated power
amplifier.
• Review the owner’s manuals for associated audio
components to determine their connection procedures.
Gauge
(AWG)
Length
(Feet)
Length
(Meters)
6 87 27
7 69 21
8 58 18
9 43 13
10 34 10
11 27 8
12 22 7
13 17 5
14 14 4
15 11 3
16 9 3
17 7 2
18 5 2
Note
High loop resistances that exceed 0.07 Ohms (for each wire run) will
cause the filter network to be mis-terminated, resulting in
considerable degradation of sound quality.