Reloop CONTOUR CONTROLLER EDITION - Manual (Page 24)

ENGLI
sh
24
4. Now select the button „Add...“ followed by „Import“.
In the selection screen open the mapping file that is on the CD or that was downloaded from the
Reloop support site.
Troubleshooting
Should a problem arise and Contour‘s LEDs are not lit correctly, then this is probably caused in
most cases by installed MIDI software (e.g. MidiYoke, Maple Virtual MIDI Cable, etc.)
In order to solve the problem proceed as follows:
1. In Traktor open the adjustment dialogue by clicking the small cog wheel in the upper right
corner.
2. Open the category „Controller Manager“.
3. For the following device entries the following port assignments have to be configured:
If several Contour devices are in use, the various in- and out-ports for the different channels have
to be divided among the devices.
Example: For 2 Contours the device entries should be manipulated as follows:
Device In-Port Out-Port
Contour V* (CH1) Reloop CONTOUR Reloop CONTOUR
Contour V* (CH2) Reloop CONTOUR Reloop CONTOUR
Contour V* (CH3) Reloop CONTOUR Reloop CONTOUR
Contour V* (CH4) Reloop CONTOUR Reloop CONTOUR
Contour V* (Master) All ports None
Device In-Port Out-Port
Contour V* (CH1) Reloop CONTOUR Reloop CONTOUR
Contour V* (CH2) Reloop CONTOUR2 Reloop CONTOUR2
Contour V* (CH3) Reloop CONTOUR Reloop CONTOUR
Contour V* (CH4) Reloop CONTOUR2 Reloop CONTOUR2
Contour V* (Master) All ports None