Kino Flo Vista Single - Manual (Page 10)

10
WARNING!
1) ALWAYS TURN OFF THE BALLAST BEFORE connecting or
disconnecting Lamps, Harnesses or Extension Cables.
2) Use only with Sine wave inverters. Do not operate on SCR dimmers.
3) If powering the ballasts through a Dimmer Pack set the Dimmer to
Non-Dim Mode.
The 120VAC Ballast requires 110 to 130 Volts AC 50/60 Hertz on an earth
grounded circuit; the 230VAC Ballast requires 220 to 240 Volts AC on an
earth grounded circuit. The electronic Ballast operates at a high frequency
of 25kHz. It is dead–quiet, instant–on and lightweight.
Load Considerations:
Kino Flo ballasts are not power factor corrected. They will draw double
the current on the neutral from what is being drawn on the two hot legs.
On large installations it may be necessary to double your neutral run so as
not to exceed your cable capacity.
To insert the cable (X07-G125), align the key-ways
on the fixture plug with the circular receptacle on the
ballast. Rotate the locking ring until it clicks into the
lock position.
Fixtures can be operated with the attached 18” tail
and the 25ft extension cable.
Ballast Operation
The Vista Single Ballast features a H0/STD switch.
This is used to adjust light level without affecting
color temperature. In STD mode the light drops
½ f-stop.
When operating the Vista Single in high ambient
temperature or where the units are rigged into place
with restricted airflow, the STD setting can be used
to lower the color temperature and remove any
green spike.