Glyph GT 062 3TB Addendum - Manual (Page 3)

3. Un-mount the volume(s) associated with the unit you are configuring by dragging them to the trash in the
Finder. This is very important to ensure successful drive mode change because it forces Mac OS to “forget”
the current configuration.
4. Click the Change Configuration button.
5. Select the desired configuration on the following screen and click the Change button. Do not select Span-
ning or Striping (RAID 0), as these modes are not supported on the GT 062 3TB model.
6. The next window requires that you verify the change request. Click OK to change the drive configuration.
NOTE: ALL DATA ON THE DRIVES WILL BE DESTROYED.
7. The next window reports that the drive configuration has changed. After a few seconds the system will
update, and Glyph Manager will display the new drive configuration. Click OK in this window.
8. At this point you may see the Mac OS Disk Insertion window. If you change to JBOD mode from a different
mode, you may see two of these windows. Now that the drive configuration has changed, Mac OS has re-
discovered the GT 062 3TB and prompts you to format the newly configured device. If you see the window
below, click Eject. If you do not see this message, simply go to step 9.