Garden Sun Heater HSS-A-GH Standard Lift Up - Manual (Page 6)

5
Step 2 – Attach Pole to Support Brackets
Put the upper pole onto the lower pole, using 2pcs
flat screws to firmly secure 2pcs pole.The warning
label on the upper pole should be on the same side as
the flat plate of the lower pole.
Install Pole onto three Support Brackets.
Attach Pole to Support Brackets using six large bolts
& six flange nuts.
Fully tighten all of the screws.
Step 3 – Load Cylinder Housing onto Pole
.
Load Cylinder Housing onto Pole.
.
Slide Cylinder Housing down.
Step 4 – Tabletop Installation
Slide fastening nut down the pole with the rounded side
faced downwards.
Next, slide the tightening spacer down the pole with the
smaller side facing downwards.
Put the table on the pole with the metallic side facing up.
6 Req’d Large Bolts 6 Req’d Small Flange Nut