E-flite FPV Vapor RTF W/ Headset - Manual (Page 6)

6
EN
The Transmitter
Installing the
Transmitter Batteries
3
4
1
2
6
5
Your ParkZone ® 4-channel
DSM2/DSMX RTF transmitter
comes pre-bound to the
aircraft.
Digital Trims
Before the first flight, center the control surfaces
mechanically (see Control Centering).
Us the digital trims to fine-tune the model’s flight
path while in flight.
When pressed down, trim buttons make a sound
that increases or decreases in pitch at each
pressing. The middle or neutral trim position is
heard as a middle tone in the pitch range of the
sounds. The end of the control range is sounded by
a series of beeps.
Mode 2 Mode 1 Transmitter Type Mode 2 Mode 1
Throttle/
Rudder
Elevator/
Rudder
Elevator/
Aileron
Throttle/
Aileron
Rudder
Trim
Rudder
Trim
Aileron
Trim
Aileron
Trim
Throttle
Trim
Elevator
Trim
Elevator
Trim
Throttle
Trim
Dual Rate Function
When powered ON, this transmitter is automatically
set to high-rate mode.
High Rate = 100% Control surface deflection
Low Rate = 70% Control surface deflection
Change rate modes by pushing the right control
stick vertically into the case (until it clicks) while the
transmitter is powered ON.
HIGH RATE
(Solid Red) ...........................
LOW RATE
(Blinking) .............................
Transmitter Control