E-flite FPV Vapor RTF W/ Headset - Manual (Page 3)

3
EN
To register your product online, go to www.e-fliterc.com
15.3
in
(389mm)
14.8 in (376mm)
.84 oz
(24 g)
Specifications
Box Contents
RTF
Includes Installed
BNF
Includes
Motor:
6mm Brushed
Receiver:
3-Ch Rx/ESC DSMX
(PKZU1152)
Ultra Micro FPV camera:
wide angle lens, Integrated
CP antenna, Compatible
with 5.8GHz Fat Shark
systems
47mm
Dual Rates and Timer Settings
Dual Rates
High Low
100 % 70%
Flight Timer
Setting
First Flight
5 Min.
6 Min.
Before first flights, or in the event of a crash,
make sure the control surfaces are centered
when the transmitter controls and trims are
neutral. The transmitter sub-trim must be set to
zero. Adjust the linkages mechanically if the control
surfaces are not centered.
Control Centering
Elevator
Control Horn Settings
Rudder
Li-P o BA TTER Y P ACK 7.4V 760mAh
Recommended Transmitter:
Spektrum ™ DSM2 ® /DSMX ® full
range (DX4e and up)
Li-Po BATTERY PACK
7.4V 760mAh
The CG location is 47mm back from the leading
edge at the wing root. This has been determined
with the included 1S 150mAh 3.7V Li-Po battery
correctly installed. Balance the model on the
edge of a metal ruler to find the Center of
Gravity. Place the ruler on the underside of the
center wing rib.