E-flite FPV Vapor RTF W/ Headset - Manual (Page 4)

4
EN
CAUTION: Only use a charger specifically
designed to charge a Li-Po battery. Failure to do so
could result in fire, causing injury or property
damage.
CAUTION: Never exceed the recommended
charge rate.
CAUTION: Always disconnect the flight
battery from the charger immediately upon
completion of charging.
Charging a fully discharged (not over-discharged)
150 mAh battery takes approximately 45 minutes at
the charger’s 300mA charge rate. The LED goes out
when the charge is complete.
Flight Battery Charging
USB Li-Po
Charger
EFLC1008
SOLID RED LED
–Charging
DC Input:5.0V 350mA
DC Output:4.2V 300mA
LED OFF
–Charge
Complete
USB Li-Po
Charger
EFLC1008
SOLID RED LED
–Charging
DC Input:5.0V 350mA
DC Output:4.2V 300mA
LED OFF
–Charge
Complete
USB Li-Po
Charger
EFLC1008
SOLID RED LED
–Charging
DC Input:5.0V 350mA
DC Output:4.2V 300mA
LED OFF
–Charge
Complete
LED Indications
CHARGING (Solid Red) ..............................
MAX CHARGE (off) ...................................
45
MIN.

1. Charge flight battery.
2. Install flight battery in aircraft (once it
has been fully charged).
3. Bind aircraft to transmitter.
4. Make sure linkages move freely.
5. Perform Control Direction Test with
transmitter.
6. Set dual rates.

7. Adjust center of gravity.
8. Perform a radio system Range Check.
9. Find a safe and open area.
10. Plan flight for flying field conditions.
11. Check the operation of FPV system.
12. Set flight timer for 5 minutes for first
flight.
Preflight Checklist