E-flite Gypsy 370 ARF - Manual (Page 25)

Motor Break-in
Required Parts
Motor
Required Tools and Adhesives
Low voltage battery source
It is suggested to break-in the motor properly and
to extend the life of the motor. Place a drop of oil
on both the front and rear bushing of the motor,
then run the motor for a few minutes on a lower
voltage source, such as 4.8 volts. This will seat the
brushes to the commutator, giving the best
performance. Apply a drop of oil after every 5–6
flights for good measure.
Motor Installation
Required Parts
Fuselage
Motor
Gearbox w/motor
3 x 10mm self-tapping screw (4)
Required Tools and Adhesives
Phillips screwdriver
❍
1. Remove the stick mount from the
gearbox assembly.
25