E-flite Gypsy 370 ARF - Manual (Page 11)

❍
4. Remove the covering from the lower front
section of the fin 3/16" (5mm) below the
lines drawn in the last step. Also make sure
there is no covering on the bottom of the fin
as indicated. Leave the covering on the top
forward fin as shown.
❍
5. Place the fin onto the top of the stabilizer.
The positioning of the fin will be as far back
in the notch as possible, aligned with the
covering removed from the stabilizer, and
square to the stabilizer. Use medium CA to
glue the fin to the stabilizer, keeping in mind
the three alignments.
11