E-flite Mini Ultra Stick ARF - Manual (Page 25)

Quad Flap Modification (Optional)
Optional Parts (for quad flaps)
• Servo w/hardware (2 additional needed)
• Servo extension, 12" (2)
• Servos extension, 3" (6)
• 7-channel receiver
• 7-channel or greater transmitter
• Micro control connector (2 additional)
• 2mm x 4mm screw (2 additional)
• Micro control connector backplate (2 additional)
• 5" pushrod wire (2 additional)
• Control horn (2 additional)
Required Tools and Adhesives
• Hobby knife • Covering iron
• Thin CA
The Mini Ultra Stick wing is designed with optional quad-
flaps. The ailerons have been designed with the option of
cutting in half using a hobby knife. White covering has been
supplied to cover the cut ends. Installing the servos is similar
to that of the aileron instructions above. There are some
additional changes.
First, you will need at least a 7-channel or greater transmitter
and receiver with servo reversing capability. Each servo
should be connected separately to the 7-channel receiver.
This will mean you should use two 12” servo extensions
to connect the two outer servos. You will also need two 3"
extensions to connect the two inner servos. We suggest you
use four additional 3" servo extensions that will connect
each servo to the receiver. This way, depending on the
receiver location, you will not have to disconnect wires
directly from the receiver each time you remove the wing.
Note: See our Mini Ultra Stick website
page for radio tips for quad flap operation
using this setup. There are also options listed
if you use a 6-channel transmitter and receiver.
However, this method will require the purchase
of a reversed servo and the use of a Y-harness
to connect your two inner location servos.
25