E-flite Mini Ultra Stick ARF - Manual (Page 18)

 4. Slide the gearbox into position on the motor
mount. Use a 1/16" drill to drill a hole on
each side of the gearbox and into the mount.
Stagger the holes so the screws will not interfere
with each other. Secure the gearbox using three
#2 x 8mm screws.
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed
to Off. Also, be sure to use an ESC with the
proper 9V cutoff when using 3-Cell Li-Po packs,
or 6V cutoff when using 2-cell Li-Po packs.
 5. Connect the ESC to the motor and secure the
ESC to the inside of the fuselage using hook and
loop material. Actual ESC location may vary.
18