Wing preparation – E-flite Mini Ultra Stick ARF User Manual

Page 22

Wing Preparation

Required Parts

• Fuselage

• Wing

• Control horn (2)

• 6-channel receiver

• Servo w/hardware (2)

• 6" Y-harness

• Servo extension, 3"

• 4-40 x 3/4" socket head screw (2)

• 3mm washer (2)

• Micro control connector (2)

• 2mm x 4mm screw (2)

• Micro control connector backplate (2)

• 5" pushrod wire (2)

Required Tools and Adhesives

• Thin CA

• Medium CA

• Ruler

• Drill

• Drill bit: 3/32"

• Screwdriver, #0 Phillips

Note: For the optional Quad Flap modification,

please refer to information on Page 25.



1. Install the aileron servo into the wing. The servo

lead will exit the hole in the bottom center of the
wing. Attach one side of a 6" Y-harness to the
servo lead. We suggest you then hook up the
Y-harness to a 3" servo extension. The 3" servo
extension can remain permanently connected to
your receiver so you do not have to unplug wires
from your receiver each time you disconnect and
remove the wing.