Watts WP12P-12PB - Manual

Poly-Alloy CrimpRing ™ Sweat Adapters are used to transition
copper pipe to WaterPEX ® supply lines. Threaded Adapters are
used for the appropriate NPT fitting.
Specifications
System shall be plumbed using Watts WaterPEX ® cross-linked
polyethylene pipe. All joints shall be made using Watts brass
CrimpRing ™ and/or poly-alloy CrimpRing ™ fittings using either
the Watts copper CrimpRing ™ or stainless steel CinchClamp ™ **
crimping methods as outlined in the Watts WaterPEX ®
Installation Guidelines.
Installation Note
CrimpRing ™ Adapters must be installed in accordance with all
Watts WaterPEX ® installation procedures, including information
provided in WaterPEX ® installation manual and guidelines.
Approvals
• Manufactured in accordance with American Society for
Testing and Materials (ASTM) F-877 and F-2159
• Listed by the National Sanitation Foundation to NSF
Standards 14 and 61 for use in potable water systems
• Listed by NSF to be in compliant to the Uniform Plumbing
Code
• Labeled B137.5 which indicates that it is compliant to the
CSA Standards B137.5
• Manufactured from Acudel ® engineered thermoplastic resin.
For Residential and Commercial Applications
ES-WP-PAAdapters
Job Name ––––––––––––––––––––––––––––––––––––––––––– Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location ––––––––––––––––––––––––––––––––––––––––– Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer ––––––––––––––––––––––––––––––––––––––––––––– Contractor’s P.O. No. ––––––––––––––––––––––––––––––––––
Approval ––––––––––––––––––––––––––––––––––––––––––––– Representative ––––––––––––––––––––––––––––––––––––––––
WP12P
Crimp x MPT Threaded
Adapter
Warning!
If connections must be made in temperatures below 30°F,
caution must be taken to allow the WaterPEX to form a proper
seal against the barb. Apply the connection slowly to ensure
the PEX material conforms to the barb.
Poly-Alloy CrimpRing ™
Adapters
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
LEAD FREE
*
* The wetted surface of this product contacted by consumable
water contains less than one quarter of one percent (0.25%) of
lead by weight.
** Note: Watts WaterPEX CinchClamp ™ fittings should not be used
with wrot copper PEX fittings.