Watts Dead LevelP - Manual

S-WD-DeadLevelFAQ
When I order Dead Level ™ ,
what comes with it?
Dead Level ™ is shipped complete with Channels
assembled to Frames, Grates, Lockdowns, Frame
Connectors, End Caps, Construction Covers, and
required Hardware.
Do I have to choose the
individual sections for my run?
No. You can order Dead Level ™ with a simple
sketch of the run, showing lengths, fl ow direction,
and outlets.
What size is the piping connec-
tion? Are other sizes available?
Piping connections for 6" wide Dead Level ™ are 4"
(102mm) No Hub. Connections for 12" wide Dead
Level are 6" (152mm) No Hub. Connections are
made with a standard no hub or transition coupling.
Other connection sizes are not available.
Is the piping connection made
on the end or bottom of the run?
Can I have multiple outlets, or slope to
the center?
A connection can be made on the bottom or end.
Closed outlets are on the bottom of each channel
section, and on the end caps. Runs may slope to the
center, away from the center, or in multiple directions.
Can I make corners or tees?
Will the joint have to be mitered?
With the Corner/Tee Section you can make a cor-
ner, tee, or cross, without mitering.
The pre-sloped system is 100' (30m)
– what if my run is longer than 100'
(30m)?
The run can be extended to any length using neutral
channel sections, or multiple outlets.
Frequently Asked Questions
Dead Level ™
Pre-sloped Trench Drain System
Q: Q:
Q:
Q:
Q:
Q:
A:
A:
A:
A:
A:
A: