Watts LFFBV-3-Press - Manual

For Press Piping Applications
ES-LFFBV-3-Press
Job Name ––––––––––––––––––––––––––––––––––––––––––– Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location ––––––––––––––––––––––––––––––––––––––––– Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer ––––––––––––––––––––––––––––––––––––––––––––– Contractor’s P.O. No. ––––––––––––––––––––––––––––––––––
Approval ––––––––––––––––––––––––––––––––––––––––––––– Representative ––––––––––––––––––––––––––––––––––––––––
LFFBV-3-Press
Series LFFBV-3-Press
2-Piece, Full Port, Lead Free* Brass
Ball Valves with Integral Press Fitting
End Connection
Designed for use in ProPress ® Piping Systems
Sizes: 1 ⁄
2
" – 2" (15 - 50mm)
The Series LFFBV-3-Press features Lead Free* construction to comply
with low lead installation requirements.
Features
• Lead Free* brass body
• Tested and Certified to NSF/ANSI 61 Annex G
1 ⁄
2
" – 2" (15 – 50mm)
• UL Listed
• Designed for types K, L, and M hard copper tubing
1 ⁄
2
" - 2"
(15 - 50mm) and soft copper tubing 1 ⁄
2
" – 1 1 ⁄
4
" (15 - 32mm)
• Press end connections comply to ASTM-B88
• Press connection rated to 200psi CWP up to 210°F
(13.4 bar to 99°C)
• Adjustable packing gland
• Bottom loaded, blowout proof stem with stem O-ring seal
Specification
Approved valve to be 2-piece, full port, forged body of Lead Free*
brass. Certified to NSF/ANSI 61 Annex G by UL for potable water
applications. Lead Free* brass ball and PTFE seats, seal, and thrust
washer required. Approved valve must have adjustable packing and
a stem O-ring seal. Valves with top loaded stems or valves without
adjustable packings are not acceptable. Press fitting rated to 200psi
CWP up to 210°F (13.4 bar to 99°C) and press ends must comply to
ASTM-B88. The valve shall be constructed using Lead Free* brass.
Lead Free* brass ball valves shall comply with state codes and stan-
dards, where applicable, requiring reduced lead content. Valve shall
be a Watts Regulator Company Series LFFBV-3-Press.
Approvals
UL Listed
Tested and Certified to NSF/ANSI 61 Annex G
ProPress® is a registered trademark of Viega N.A.
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
LEAD FREE
*
* The wetted surface of this product contacted by consumable
water contains less than one quarter of one percent (0.25%) of
lead by weight.