Watts WP13B - Manual

Brass CrimpRing ™
Adapters
Brass CrimpRing ™ Sweat Adapters are used to transition
copper pipe to WaterPEX ® supply lines. Threaded Adapters
are used for the appropriate NPT fitting.
Specifications
System shall be plumbed using Watts WaterPEX ® cross-linked
polyethylene pipe. All joints shall be made using Watts brass
CrimpRing
™ and/or polyalloy CrimpRing ™ fittings using either
the Watts copper CrimpRing ™ or stainless steel CinchClamp ™ *
crimping methods as outlined in the Watts WaterPEX ®
Installation Guidelines.
Installation Note
CrimpRing ™ Adapters must be installed in accordance with all
Watts WaterPEX ® installation procedures, including information
provided in WaterPEX ® installation manual and guidelines.
Approvals
• Manufactured in accordance with American Society for
Testing and Materials (ASTM) F-877 and F-1807
• Listed by the National Sanitation Foundation to NSF
Standards 14 and 61 for use in potable water systems
• Listed by NSF to be in compliant to the Uniform Plumbing
Code
• Labeled B137.5 which indicates that it is compliant to the
CSA Standards B137.5
For Residential and Commercial Applications
ES-WP-BrassAdapters
Job Name ––––––––––––––––––––––––––––––––––––––––––– Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location ––––––––––––––––––––––––––––––––––––––––– Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer ––––––––––––––––––––––––––––––––––––––––––––– Contractor’s P.O. No. –––––––––––––––––––––––––––––––––––
Approval ––––––––––––––––––––––––––––––––––––––––––––– Representative ––––––––––––––––––––––––––––––––––––––––
WP10
Male Sweat x Crimp
Adapter
WP11
Female Sweat x Crimp
Adapter
WP13
Crimp x FPT Threaded
Adapter
WP12
Crimp x MPT Threaded
Adapter
* Note: Watts WaterPEX CinchClamp ™ fittings should not be
used with wrot copper PEX fittings.
W a r n i n g !
If connections must be made in temperatures below 30°F,
caution must be taken to allow the WaterPEX to form a proper
seal against the barb. Apply the connection slowly to ensure
the PEX material conforms to the barb.
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
ES-WP-BrassAdapters.qxd 3/16/09 1:07 PM Page 1