Metrohm TitrIC 3 - Manual

Application Bulletin 287 e
Version 1.0
Installation Instructions of TitrIC 3
861 Dual Channel Advanced Compact IC with 815 USB
Sample Processor
VENT
10 mL
800 Dosino
Metrohm
VENT
50 mL
800 Dosino
Metrohm
VENT
20 mL
800 Dosino
Metrohm
815
HNO 3
712 3 x 800 2.861.0010 2.861.0020 809
The TitrIC 3 System with two 861 Compact ICs, 815 Robotic USB Sample Processor and 809 Titrando
The TitrIC 3 System is used for the fully automatic analysis of water samples using direct measure-
ment, titration and ion chromatography. The caps of the air protected sample beakers are discovered
with the DIS-COVER function of the 815 and the following measured values are determined in a very
short time: temperature, conductivity, pH, acid capacity and, in parallel, the concentrations of the
individual anions and cations. Further Metrohm instruments can be incorporated in the existing system
at any time and used to measure additional parameters.
Analytical sequence
1. Conductivity is measured in the sample vessel on the sample changer.
2. First sample transfer to the two 861 Advanced Compact ICs.
3. The IC measurements are started automatically.
4. Second sample transfer to the external cell of the 815 Robotic Sample Processor.
5. Temperature, pH and acid capacity (p and m values) are determined.
The whole procedure is controlled by the TitrIC software: The user enters the sample position and
sample identification, IC system and tiamo method, after which TitrIC transfers all the relevant
information to tiamo and IC Net. When the measurement has been concluded, TitrIC automatically
generates a joint report containing all results. This report can be printed out or produced as an Excel
table.