Metrohm TitrIC 7 - Manual (Page 10)

Application Bulletin 321 e
Installation Instructions of TitrIC 7
Page 10/16
ƒ Conductivity cell (6.0912.110): The measuring cell cable is led through the guide chain of the
855 and the plug is inserted into the opening marked Cond. Cell of the 856 Conductometer. Later
(as soon as the titration head has been mounted) the measuring cell with the SGJ sleeve
(6.1236.050) will be inserted in the SGJ 14 opening of the titration head.
6 Software
6.1 Installation of the software
ƒ tiamo TM
2.1 – installation (tiamo
TM
CD): All the standard directories proposed by the program
should be accepted.
ƒ MagIC Net 2.0 – installation (MagIC CD): All the standard directories proposed by the program
should be accepted. Restart windows.
ƒ TitrIC 2.0 – installation (TitrIC CD): TitrIC 2.0 must only be installed after tiamo TM
2.1 and
MagIC Net 2.0 have already been installed. After installation the standard TitrIC directory can
be found under
C:\Program files\ Metrohm\TitrIC , the TitrIC.exe file under C:\Program
files\Metrohm\tiamo\bin . The TitrIC database, reports are found on C:\Documents and Settings\All
Users\ApplicationData\TitrIC.
Æ All programs should be closed!
6.2 Configuration of tiamo
TM
Æ The Controller cable (6.2151.000), which is already connected to the 855, is now connected to an
USB interface on the PC. Wait a few seconds. The driver installation for the 855 follows. It’s not
necessary to start windows update, click on
automatic installation of the software for both.
Æ The controller cable (6.2151.000), which is already connected to the 856 conductivity module, is now
connected to an USB interface on the PC
Æ tiamo TM
2.1 is started
6.2.1 Devices
Connected USB devices are automatically recognized when tiamo
TM
is started. After confirmation of the
automatically generated request, the devices are stored in the configuration. Keep the proposed device
names.
6.2.2 Swing Head configuration
Under Configuration at the top left, double-click on 855_1 under Devices , click on the entry Tower 1 , set the
Axial distance to 196.0 mm and in the middle of the window under Swing Head click on Configuration and Yes
and then enter the following values:
Configuration of the Swing Head