Metrohm 850 Professional IC Anion MSM-HC MCS Gradient - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
850 Professional IC
￭￭￭￭￭￭￭￭ 13
3 Installation
3.1 About this chapter
The Installation chapter contains
￭ this overview
￭ a brief set of instructions for the initial installation of the 850 Professio-
nal IC – Anion – MSM-HC – MCS – Gradient (see Chapter 3.2, page
13) as an isocratic system. At each step you will find cross-references
to more detailed installation instructions for individual components,
should you require such aids.
￭ an installation diagram (see Figure 3, page 17), showing a com-
pletely installed instrument.
￭ several chapters with detailed installation instructions for all compo-
nents, including those that are already installed at the time the instru-
ment is delivered.
3.2 Initial installation
Note
A large number of the capillary connections are already connected at
the time the instrument is delivered.
Installing 850 Professional IC – Anion – MSM-HC – MCS –
Gradient
1 Setting up the instrument
See Chapter 3.4, Page 19.
2 Installations on the rear of the instrument
￭ Remove handle and rollers (see Chapter 3.6.1, page 21).
￭ Place the detector in the instrument and connect it (see Chapter
3.6.2, page 24).
￭ Remove transport locking screws (see "Removing transport lock-
ing screws", page 26).
￭ Connect the leak sensor (see "Connecting the leak sensor", page
26).