Metrohm 930 Compact IC Flex ChS - Manual (Page 26)

3.5 Connecting the eluent bottle
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
18 ￭￭￭￭￭￭￭￭
930 Compact IC Flex ChS (2.930.1200)
Route the loose end into a waste container.
3.4.2 Connecting the leak sensor
Plugging in the leak sensor connection cable
The leak sensor connection cable is coiled up in the base tray.
1 Pull the leak sensor connection cable out of the base tray as far as
needed.
2 Plug the plug for the leak sensor connection cable into the leak sen-
sor connection socket (labeled Leak Sensor).
3.5 Connecting the eluent bottle
The eluent is aspirated out of the eluent bottle via the eluent aspiration
tubing . The eluent aspiration tubing is installed on the input for the high-
pressure pump.
The tubing has to be be fed out of the instrument through a suitable
opening (see "Openings on the back panel", page 10) before the loose
end can be connected to the eluent bottle.
Accessories For this step you need the following accessories:
These parts are part of the accessory kit Vario/Flex ONE (6.5000.010).
￭ Eluent bottle (6.1608.070)