DJI Phantom 2 FPV HUB Kit User Manual

Page 3

module, connect it to the FPV HUB via HUB-VTX cable according to

pins description of the HUB-VTX cable.

GND

GND wire from PHANTOM 2, connect it to the GND port of wireless

video transmission module.

VCC

Power wire from PHANTOM 2 provides 1.5A@12V power. Connect it

to the VCC port of wireless video transmission module.

VIDEO_GND

GND wire of analog video signal, connect it to the VIDEO_GND port

of wireless video transmission module. If the video transmission

module used has only one GND port on the transmitter, it’s alright to

connect both GND and VIDEO_GND to the only GND port.

VIDEO

For analog video output, connect it to the video input port of the

wireless video transmission module.

Collocation 2&3: iOSD mini/iOSD MARK II and video transmission

module connected

To the CAN-
BUS Connector
of PHANTOM 2

HUB-iOSD mini cable

Micro switch stops at

OSD

Connecting with the

8-Pin cable reserved

in PHANTOM 2

HUB-ZEN cable

HUB-AVL58 cable

A V L 5 8

T R A N S M I T T E R

HUB-iOSD Mark II cable

To the CAN-BUS

Connector of PHANTOM 2

-V

DJI unspecified wireless video

transmission module

1) It’s alternative to use iOSD mini or iOSD Mark II.

2) Stop the Micro switch at OSD position when iOSD is connected to