DJI Naza-H - Manual (Page 5)

©2012 DJI Innovations. All Rights Reserved. 4 |
Step
2
Software and Driver Installation
STEP1 Please download driver DJI Driver Installer.exe and assistant software from DJI website.
STEP2 Connect the NAZA-H and the PC via USB cable, power on the NAZA-H system.
STEP3 Run DJI Driver Installer.exe, and follow the instructions strictly to finish installation.
STEP4 Run assistant software installer, and follow the instructions strictly to finish installation.
Step
3
Assistant Software Usage
STEP1 Connect the NAZA-H to the PC with a Micro-USB cable. DO NOT break the connection until
setup is finished.
STEP2 Run the NAZA-H Assistant Software。
STEP3 If the communication indicator is on, please double check the connections and driver installation;
otherwise if the indicator is blinking, go to next step.
STEP4 Select InfoSoftware and Firmware. Check whether the assistant software and the firmware
upgrade are available. If available, please upgrade the assistant software and the firmware by
referring to the appendix. Otherwise, go to next step.
STEP5 Select Setup. Please follow step-by-step for your first-time-configuration.
STEP6 Select Common and fill in the required values. You can click the Advanced option for more
parameter settings.
STEP7 Check your R/C transmitter channels through the channel monitor. Monitor the servo battery and
main battery voltages. Choose and set the warning voltage for servo battery and main battery.
Make sure the helicopter parameters set by the setup wizard are correct. Observe the tail gyro
gain settings indicated in the status bar at the bottom of the software window.
Tips:
Please make sure to set the tail gyro gain using the R/C transmitter, using the G channel of NAZA-H main
controller.