DJI Naza-H - Manual (Page 10)

©2012 DJI Innovations. All Rights Reserved. 10 |
Appendix
Firmware & Assistant Software Upgrade
Please follow the procedure for software and firmware upgrade; otherwise the NAZA-H might not work
properly.
STEP1 Make sure your computer is connected to the Internet.
STEP2 Please close all the other applications during the firmware upgrade, including anti-virus software
and firewall.
STEP3 Make sure the power supply is securely connected. DO NOT un-plug the power supply until
firmware upgrade has finished.
STEP4 Connect NAZA-H to PC with Micro-USB cable, DO NOT break connection until firmware upgrade
is finished.
STEP5 Run Software and wait for connection.
STEP6 Select InfoSoftware and Firmware.
STEP7 DJI server will check your current software and firmware version, and get the latest software and
firmware prepared for the unit.
STEP8 If there is a software version more up-to-date than your current version, you will be able to click to
download the new version. Please re-install the assistant software follow the prompts
STEP9 If there is a firmware version more up-to-date than your current version, you will be able to click to
update them. Wait until Assistant software shows “finished”. Click OK and power cycle the unit
after at least 5 seconds.
STEP10 Your unit is now up-to-date.
Note:
 After firmware upgrade, please re-configure the NAZA-H using Assistant software.
 If the network or DJI server is busy, try again later with above procedures.
 If firmware upgrade failed, NAZA-H will enter waiting for firmware upgrade status automatically,
please try again with the above procedures.
 You may be asked to register by filling in the contact information before upgrade.