DJI S800 EVO - Manual (Page 7)

Center Frame Wiring
The top board is a power distribution board, and the bottom board is for loading autopilot system components.
Top Board
Bottom Board
Buckle
Slot
M1
M2
M
3
M4
M
6
M5
B
A
T
T
P
M
G
IM
B
A
L
IMU Front
Aircraft Nose
To Battery
To PMU
XT60 Male
XT60 Female
XT60 Female
To Gimbal M1
M2
M3
M4
M5
M6
Motor clock-wise
ESC signal outlet
To main controller
Mark
IMU mount position
Circuit line
Parallel Circuit
Motor number
Mark
Motor counter clock-wise
Mark
Top Board
Notes:
(1) For IMU mounting, make sure the arrow direction marking on the IMU is pointing to the aircraft nose.
(2) Connect the 3-pin connectors (M1~M6) of servo cable from WKM M.C. to ESC signal socket (M1~M6) on
center frame markings accordingly.
(WKM M.C. M1 ESC signal socket M1, …… , WKM M.C. M6 ESC signal socket M6)
Tips:
(1) The main battery power leads, gimbal and PMU leads are on the bottom surface of the top board.
(2) Markings and stand for the propeller rotation direction. means clock-wise, and means
counter clock-wise.
(3) If other lead connector is required, please cut the original connector and solder on the new one. (But NOT
Recommend.)