DJI S800 EVO - Manual (Page 15)

Tips
(1) The system will turn off the servo power temporarily within 3 seconds after the landing gear has reached
the target position.
(2) When powering on the system, if the Transmitter switch is at the [Retracted] position, which is the unsafe
signal for the landing gear, the LED will quickly flash RED. Toggle the switch to the [Lower] position.
(3) If there is an abnormal signal or no signal input into the [IN] port the LED will slowly flash RED. Please
check the receiver and the connections.
(4) If the power consumption of servos is too large during usage, the LED will be solid RED on. If this status
lasts more than 4 seconds, the landing gear will lower and the LED will flash GREEN slowly. Please
re-calibrate the system.
LED Indicator
System works normally
Hasn’t been calibrated
Need re-calibration
Wrong calibration
Enter the calibration mode
System is calibrating
Motor stall
Input signal is unsafe when power on the Transmitter
Input signal is abnormal
Specifications
Parameter Range Parameter Range
Working Voltage 3S~6S (LiPo) Input Signal PWM (High-Pulse Width 800us~2200us)
Working Current Max 1A@6S Output Signal PWM(Mid Position is 1520us) in 90Hz
Working Temperature -20~70 o C Output Voltage 6V
Total Weight 875g Servo Travel 150 o (Minimum120 o )