CommScope ATC200-1000 - Manual (Page 5)

4c. Adjusting the downtilt angle on a group of antennas.
• As shown on the screen below, click on the Additional models, one
at a time, to be included in the sector move.
• Click on Add. (Double-clicking on the model will also add it to the
group for the sector move.)
• Enter the new electrical tilt angle. Review the Electrical Tilt range to
verify that the new tilt angle entered is valid for the antenna model.
Angles may be entered as whole degrees or as a combination of
whole degrees and tenths of a degree (Ex: 5.0 or 5.5).
• Click on Set Tilt.
4b. Device adjustments for a group of antennas.
Click on a device that is to be included in the sector move, and click
Move Sector.
See screen 1, below.
4a. Device adjustments for a single antenna.
• To change electrical downtilt on a single antenna, select the antenna
actuator that will be tilted, and click Move Selected (screen 1).
• Enter the new electrical tilt angle and click on Set Tilt (screen 2).
1
2