CommScope ATC200-1000 - Manual (Page 4)

3b. Make appropriate selections and text entries on screen below.
• To receive commands from the controller, a device must be conf gured
to provide specif c information about the antenna and its location on
site.
• Factory installed actuators are pre-conf gured to include the antenna
model number, antenna type, and antenna serial number.
• The remaining f elds (Installation Date, Base Station ID, Mechanical
Tilt, Technology, Freq. Band, Sector, Location, Bearing, Height, and
Installer ID) will need to be conf gured.
• After entering data , click on Set Device Data.
Note: Click on Close to return to the controller’s main screen when
device conf guration is complete.
3a. Device conf guration.
Select appropriate device to be conf gured and click on Edit Selected.
3. Device confi guration and adjustments
Note: See www.commscope.com for complete user guide, Bulletin 639514.
www.commscope.com/andrew
Visit our Web site at www.commscope.com or contact your local Andrew representative for more information.
© 2009 CommScope, Inc. All rights reserved.
Andrew is a trademark of CommScope. All trademarks identif ed by ® or ™ are registered trademarks or trade-
marks, respectively, of CommScope. This document is for planning purposes only and is not intended to modify
or supplement any specif cations or warranties relating to Andrew products or services.
Andrew, A CommScope Company
Customer Support Center
North America:
+1-800-255-1479,
Option 1
International: +1-779-435-6500,
Option 1