Clay Paky GLOW UP & FLIGHT CASE (F21230) - Manual (Page 5)

5 GLOW UP
3
Projector installation - Fig. 3
The projector can be installed on the floor resting on specific rubber feet, on a truss, on the ceiling or wall.
WARNING: the safety chain must be installed except when the projector rests on the floor. (Code 105015/801 available upon request). This
must be secured to the projector support structure and then hooked to the fastening point at the centre of the base.
1
2
3
2
3
1 4
4
Connecting and disconnecting the power cord - Fig. 4
When connecting the power cord the user can choose whether to use the GlowUp in one of the following ways:
1) Power cord connected for battery charge.
2) Power cord connected for projector power (thus bypassing battery operations).
The GlowUp cannot work in both ways simultaneously.
INSTALLATION AND START-UP