Calculated Industries 6020 v2.0 - Manual (Page 11)

ii. If you do not want to change the
unit of measure, go to step iii. To
change the unit of measure, press
[M1+] until you reach the desired
unit.
iii.Press [Scale] to advance through
the flashing digits until the display
returns to zero. The height is now
stored.
b. To Enter and Store a Height:
i. If you are entering a height (instead
of rolling), press [Subtract/Count]
and [M2x] simultaneously. The unit
of measure will begin flashing.
ii. If you do not want to change the
unit of measure, go to step iii. To
change the unit of measure, press
[M1+] until you reach the desired
unit.
iii.Press [Scale] to begin setting the
digits. The left-most digit will
begin flashing.
Press:
[M1+] to increment this digit
[Subtract/Count] to decrement
[Scale] to advance to next digit
[Mode] to move back one digit
iv. Continue pressing [Scale] until all
digits are set and the display returns
to zero. The height is now stored.
Note: Once you set your height, you do not need
to enter it again unless you want to change it.
11 – User’s Guide
6020UG-EFS-C 6/27/03 2:19 PM Page 11