Barbie JAMMIN' JEEP T8396 - Manual (Page 12)

12 T8396pr-0920
ASSEMBLY
16
17
• Insert each fastener end of the long seat belt strap
through a slot in the center of the seat. Make sure the
fasteners face the outer edge of the seat.
• Pull each side of the long seat belt strap evenly
through the slots. Make sure to pull each T-loop
through a slot.
• Turn the seat upright.
T-Loop
Fastener End
Long Seat Belt Strap
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap
through the slot near the outer edge of the seat.
Make sure the side of the seat belt with the fastener
faces the outer edge of the seat.
• Pull the short seat belt strap completely through the
slot until the last T-loop at the opposite end of the
belt catches against the slot. You will pull one T-loop
through the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
Short Seat
Belt Strap
Fastener End
Seat
Slot
T-Loops
Slot
T-Loop (Pull through slot)
Seat
Seat Back
Tabs
Slot
Tabs
A
B
C
PUSH
HERE
• With the seat at an angle, insert the tabs on the front
edge of the seat into the slots in the foot-well wall A .
• Push down firmly on the edge of the seat above each
tab to snap the tabs into the slots B .
• Rotate the back of the seat down C to snap the seat
back tabs into the slots in the vehicle. Push down firmly
on the seat back.
SIDE VIEW
18
• Insert a #10 x 3 /
4
" screw into the rear edge of the seat.
Tighten the screw.
BACK VIEW
19