Bully Dog 221102 Rapid Flow Induction - Manual (Page 5)

4. Locate the air sensor on the right side of the
intake. Remove the sensor from the intake
by twisting it counter clockwise and pulling
it out.
5. Remove the nut at the back right side of
the intake by removing with a 10mm end
wrench. (Save this nut for later use). Finally
remove the intake from the vehicle by pull-
ing it straight up to release it from the two
rubber grommets which hold it in place. If
the grommets come off with the intake
housing, remove them from the intake hous-
ing and store for later use.
RAPID FLOW INDUCTION
Remove Air Sensor
Air Sensor
Remove Nut
Intr
odu
ctio
n
Stock Remo
val
RFI I
nsta
llati
on
Filte
r M
ain
ten
ce
Tro
uble
sho
otin
g/F
AQ
W
arra
nty
/Dis
cclia
m
er
Note: it is recommended that you use a silicone spray to make removing the rubber grommets from
the stock intake easier.