Bully Dog 82200 Rapid Flow - Manual (Page 7)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82010,82200
2. Place all of the supplied Hangers into their appro-
priate locations as shown in the above diagram.
Hangers may serve a dual purpose, acting as both
clamps and hangers.
3. Bolt the Down Pipe in place using
the stock 13mm bolts. To make start-
ing the bolts easier, start one bolt
just barely so that it holds and then move to the
other so that both sides are pulling evenly on the
bracket.
4. Using Hanger A as a clamp, tighten it down
enough to hold the first Straight Pipe in place.
Both Straight Pipes are exactly the same and are
interchangeable.
13mm
Down Pipe
Hanger Locations
Install Down Pipe
Install Hanger A
Hanger C
Hanger B
Down Pipe Bolts
Hanger A