Bully Dog 82020 Rapid Flow - Manual (Page 9)

10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82020
Complete System Installed
9. At this point, it is time to install the Straight
Pipe. Cut the Straight Pipe to the desired
length, keeping in mind that you
need 3 inches of overlap when you
cut the pipe. Do not cut the flarred
end.
10. Once the entire exhaust system is installed,
inspect the system to ensure that no part of the
exhaust is in direct contact with the chassis or
body; adjustments may be necessary. Having
any part of the exhaust system in direct contact
with any part of the body or chassis will cause
the exhaust to rattle.
11. Return to each of the Clamps and tighten
with a 9/16” wrench or socket. Again do not
over tighten the Clamps.
Measure for Straight Pipe
3”
9/16”
Important: Do not over-tighten clamps. too much torque will result in deformation of the exhaust. For best
results when doing the installation, tighten the clamps enough to hold the exhaust pieces in place, but don’t
tighten down until the entire exhaust system is installed.