Bully Dog 82020 Rapid Flow - Manual (Page 5)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82020
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust
system.
1. You will need a ratchet with a 24”
extension in order to remove the
stock13mm bolts that hold the down
pipe onto the turbo. You may have to
combine different extensions to make the 24” exten-
sion. It is recommended that you use a silicone spray
lubricate to help make the process easier. You will
reuse the stock bolts to attach the
new Rapid Flow exhaust.
2. Cut the stock exhaust in three
places. Using a sawzall make your
first cut directly behind the muffler.
3. Cut in front of the resonator.
4. Cut the bottom of the downpipe where the stock
exhaust makes its bend.
5. Remove each piece of the stock exhaust system,
including the stock
exhaust hangers. Use
Spray lubricant to aid in the removal of the hangers.
Cut after the bend of the downpipe
Cut Exhaust directly after muffler
Cut Exhaust in front of resonator
Remove 13mm Bolts with 24” Extension
Remove Stock Hangers
13mm