Bully Dog 82021 Rapid Flow - Manual (Page 9)

10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82021
8. At this point it is time to install the Straight Pipe (s). You will need to measure and cut the Straight Pipe
(s) for the final fit. Keep in mind when you make your final cut you will need to leave an extra 3 inches of
overlap when you cut the Straight Pipe. Don’t cut the flared end.
9. Once the entire exhaust system is installed, inspect the system to ensure that no part of the exhaust is in
direct contact with the chassis or body; adjustments may be necessary.
10. Return to each of the Clamps and tighten with a 9/16” wrench. Do not over tighten the
Clamps.
9/16”
40”
Measure for Straight Pipe
Complete System Installed
3”