Bully Dog 82021 Rapid Flow - Manual (Page 8)

9
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82021
5. Hang the Muffler from Hangers B & C.
6. Install the Front Piece Tail Pipe by sliding it into
the Muffler and tightening Hanger C to hold it in
place. Ensure that the bend of the Front Piece Tail
Pipe is directly over the axle. At this point don’t
tighten down Hanger C completely, instead wait
until the entire exhaust is installed before tight-
ening everything down completely.
7. Install the Tail Pipe Tip by sliding it into the Front
Piece Tail Pipe and hanging it from Hanger D. Se-
cure with a clamp.
SwITCH DIRECTIONS: THE NEXT STEPS wILL BE FROM THE BACk OF THE TRUCk
Install Muffler
Install Front Piece Tail Pipe
Install Tail Pipe Tip
Hanger B
Front Piece Tail Pipe
Hanger D
Hanger D
Front Piece Tail Pipe
Tail Pipe Tip