Bully Dog 82021 Rapid Flow - Manual (Page 5)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82021
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust
system.
1. Use a sawzall to cut the exhaust directly behind the
muffler.
2. Cut the Straight Pipe in front of the muffler.
3. Cut the stock Down Pipe just after the bend.
4. Loosen the stock band clamp using a 7/16” deep
socket where the stock down pipe is connected to
the turbo. The stock band clamp will be used later
so don’t remove it, just loosen it enough to remove
the stock down pipe.
5. To make removing the Hangers
an easier process it is recommended
that you use a silicone spray lubricant
to spray each of the rubber hangers
holding the stock exhaust.
6. Remove each piece of the stock exhaust system,
including the stock exhaust hangers.
Remove all the necessary exhaust hangers
Cut directly in front of the Muffler
Loosen Stock Band Clamp
7/16”