Bully Dog 82022 Rapid Flow - Manual (Page 5)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82022
Important: It is illegal in all 50 states and Canada to remove the catalytic converter.
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.
1.Use a sawzall to cut the exhaust directly behind
the muffler.
2. Cut the Straight Pipe in front of the muffler.
3. Cut the stock Down Pipe just after the bend.
4. Loosen the stock band clamp using a 7/16”
deep socket where the stock down pipe
is connected to the turbo. The stock band
clamp will be used later so don’t remove it,
just loosen it enough to remove the stock
down pipe.
5. To make removing the Hangers an easier
process it is recommended that you use a
silicone spray lubricant to spray each of the
rubber hangers holding the stock exhaust.
6. Remove each piece of the stock exhaust system, including
the stock exhaust hangers.
Cut directly in front of the Muffler
Cut 4” behind the Catalytic Converter
Remove all the necessary exhaust hangers