Bully Dog 82222 Rapid Flow - Manual (Page 9)

10
RAPid FlOW inSTAllATiOn
Rapid Flow Exhaust # 82222
10. At this point, it is time to install the other
Straight Pipe. Cut the Straight Pipe to the de-
sired length, keeping in mind that you need 3
inches of overlap when you cut the pipe. Do
not cut the flared end.
11. Once the entire exhaust system is in-
stalled, inspect the system to ensure that no
part of the exhaust is in direct contact with
the chassis or body; adjustments may be nec-
essary. Having any part of the exhaust system
in direct contact with any part of the body or
chassis will cause the exhaust to rattle.
12. Return to each of the Clamps and tighten
with a 9/16” wrench or socket. Again do not
over tighten the Clamps.
Complete System Installed
Measure for Second Straight Pipe
Cut Straight pipe to Desired Length
3”
9/16”
Important: Do not over-tighten clamps. too much torque will result in deformation of the exhaust. For best
results when doing the installation, tighten the clamps enough to hold the exhaust pieces in place, but don’t
tighten down until the entire exhaust system is installed.