Bully Dog 82223 Rapid Flow - Manual (Page 6)

7
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82223
QUICk OVERVIEw FULL EXHAUST
Muffler
Driver Tail Pipe Tip
24” Straight Pipe
Driver Front Piece Tail Pipe
48” Straight Pipe
Down Pipe
Passenger Front Piece Tail Pipe
Passenger Tail Pipe Tip
Y-Pipe
CLAMP AND HANGER PLACEMENT
Hanger C
Hanger A
Hanger D
Hanger B
Clamp
Clamp
Clamps
Clamps
Hanger E
In these steps you will install the rapid Flow Exhaust System. Bully Dog’s Exhaust Systems are one-
cut systems, meaning that you should only have to cut one pipe or less if installed correctly.
1. It is suggested that before installing the system on the truck, the Rapid Flow Exhaust System be laid out on a
large flat surface to acknowledge the location of each piece
tool s needed:
Silicone Spray Lubricant •
9/16” Wrench •
7/16” Deep Socket •
Socket Wrench •
tape measure •
INSTALLATION OF THE BULLy DOG RAPID FLOw EXHAUST SySTEM