Bully Dog 82223 Rapid Flow - Manual (Page 5)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82223
Important: It is illegal in all 50 states and Canada to remove the catalytic converter.
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.
1. Use a sawzall to cut the exhaust directly be-
hind the muffler.
2. Cut the Straight Pipe in front
of the muffler.
3. Cut the stock Down Pipe just after the bend.
4. Loosen the stock band
clamp using a 7/16” deep
socket where the stock
Down Pipe is connected to the turbo. The
stock band clamp will be used later so don’t
remove it, just loosen it enough to remove
the stock Down Pipe.
5. To make removing the
Hangers an easier process
it is recommended that you use a silicone
spray lubricant to spray each of the rubber
hangers holding the stock exhaust.
6. Remove each piece of the stock exhaust sys-
tem, including the stock exhaust hangers.
Cut directly in front of the Muffler
Remove all the necessary exhaust hangers
Loosen stock band clamp
7/16”