Bully Dog 82202 Rapid Flow - Manual (Page 9)

8
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82400,82202
9. At this point it is time to install the
Straight Pipe(s). You will need to measure
and cut the Straight Pipe(s) for the final fit.
Keep in mind when you make your final
cut you will need to leave an extra 3 inch-
es of overlap when you cut the Straight
Pipe. Do not cut the flared end.
10. Once the entire exhaust system is in-
stalled, inspect the system to ensure that
no part of the exhaust is in direct contact
with the chassis or body; adjustments
may be necessary.
11. Return to each of the Clamps and tight-
en with a 9/16” wrench. Do not
over tighten the Clamps.
Complete System Installed
9/16”
Measure Straight Pipe
Hanger A
Muffler
Clamp
Straight Pipe
3”