Bully Dog 82210 Rapid Flow - Manual (Page 6)

5
rAPid FlOW inSTAllATiOn
Important: Do not over-tighten Clamps. too much torque will result in deformation of the exhaust. For best results
when doing the installation, tighten the Clamps enough to hold the exhaust pieces in place, but don’t tighten down until
the entire exhaust system is installed.
In these steps you will install the rapid Flow Exhaust System. Bully Dog’s Exhaust Systems are one-
cut systems, meaning that you should only have to cut one pipe or less if installed correctly.
1. It is suggested that before installing the system on the truck, the Rapid Flow Exhaust System be laid out on a
large flat surface to acknowledge the location of each piece.
2. Install the adapter at the back of the DPF. Insure that the band clamp is on before installing.
Adapter
INSTaLLaTION Of ThE BULLy DOG RaPID fLOw ExhaUST SySTEM
Diesel Particulate Filter