Rfi cold air intake, Filter maintenance – Bully Dog 53206 Rapid Flow Induction (RFI) Cold Air Intake User Manual

Page 13

RFI COLD AIR INTAKE

FILTER MAINTENANCE

The intake system should be cleaned with the Bully Dog RFI

Cleaning Kit at least once every three months; in dusty cli-

mates, the filter should be cleaned more often. Cleaning the

intake is a two part process: cleaning and oiling the filter.

Cleaning the Filter

I. Remove the filter from the RFI enclosure. Clean the enclosure if

necessary.

II. Remove surface dirt (this step can be avoided

if a Bully Dog RFI Prefilter has been installed).

A. Lightly tap the filter.

B. Use a soft-bristle brush to remove any loose

particles.

III. Spray the cleaner generously over the filter and

let it soak for 10 minutes.

IV. Thoroughly rinse the filter.

A. Use regular tap water.

B. Avoid high-pressure hoses.

V. Prevent dirt from entering the filter by rinsing

from inside out or from the clean side to the

dirty side.

VI. Let the filter air dry.

A. Do not use any method to speed up the drying

process.

B. Using a blow dryer or compressed air can disfigure

the filter and allow particles to pass through.