beautypg.com

Rfi cold air intake – Bully Dog 53206 Rapid Flow Induction (RFI) Cold Air Intake User Manual

Page 10

background image

RFI COLD AIR INTAKE

10

Preparing the RFI Intake

I. Remove the MAF sensor

assembly from the stock

filter housing.

A. Use a flat-head

screwdriver to loosen the

band clamp.

II. Connect the stock MAF

sensor assembly to the

RFI MAF Tube.

A. Make sure the pieces

line up as shown in the

photo.

B. Use a flat-head

screwdriver to tighten the

band clamp.

III. Snap the MAF assembly

into the RFI Base.

A. The sensor should be up,

as shown in the photo.

IV. Attach the hump coupler to the MAF

sensor side of the Stage 2 RFI Tube.

V. Attach the straight coupler to the

throttle body side of the Stage 2 RFI

Tube.Slide two band clamps over each

coupler (do not tighten yet).

See also other documents in the category Bully Dog For the car: