Bully Dog 182060 Dodge 5.9L Cummins 2500-3500 94-02 - Manual (Page 7)

rAPid FlOW inSTAllATiOn
ImpoRTaNT: Do Not over-tighten clamps. Too much torque will result in deformation of the exhaust. For best results
when doing the installation, tighten the clamps enough to hold the exhaust pieces in place, but don’t tighten down until
the entire exhaust system is installed.
1. It is suggested, that before installing the
system on the truck the Rapid Flow Ex-
haust System be laid out on a large flat
surface to acknowledge the location of
each piece.
2. Place all of the supplied Hangers into
their appropriate locations as shown
in the above diagram. Most Hangers
will serve a dual purpose, acting as
both clamps and hangers. Hanger A
will serve as the clamp between the
Down Pipe and the Adapter with Offset.
Hangers B and C will act as both clamps
and hangers to hold the muffler. Hanger
D will hold the Tail Pipe Tip.
3. Bolt the Down Pipe in place using the
stock 13mm bolts.
4. Using Hanger A as a clamp, tighten it
down enough to hold the Adaptor with
Offset in place.
Hanger A
Hanger B
6
Hanger Locations Hanger C
Hanger B
Hanger C
Hanger D
Adaptor with Offset
INSTALLATION OF THE BULLY DOG RAPID FLOW EXHAUST SYSTEM