Bully Dog 40602 Adjustable Power Punch - Manual (Page 6)

5
oPErAtIng InStructIonS:
1. After completing the installation of the module, set
the toggle to 10% and turn the tractor or combine
on to test if the module is working. If the tractor
starts then the module is working. If the tractor does
not turn on then check all of the connections on the
install to be sure that they are secure and then at-
tempt to start the tractor again.
2. While operating the tractor with the three new set-
tings the operator can accomplish a few different
things that will be seen as a benefit to the operator
and the owner:
Operating instructions
*Only on Adjustable Power Punch
RECOMMENDED MODULE USES
SAvE FUEL:
The operator of the tractor with more power can use the power to grab a higher gear and they can main-
tain the same speed in the higher gear or just go a little quicker. The operator will notice that it takes less
throttle to accomplish the same speed as with stock horsepower levels, with the module installed.
MOvE qUICkER:
The operator as long as they are pulling the same implements in comparison can move at a higher rate of
speed therefore allowing them to finish jobs quicker.
PULL hEAvIER IMPLIMENTS:
The power module increases horsepower dramatically allowing smaller tractors to pull larger implements.
When pulling large impliments with a small tractor it is important to have a pyrometer which monitors
exhaust gas temperatures.